Powertrain (P) · ECM
Harley Code P0603
ECM EEPROM memory error
What P0603 means
The engine control module detected an internal memory or processor error.
The fault type in P0603
Internal module fault
The module's own self-test found a problem inside it. Low or unstable supply voltage can trigger a false internal fault, so the power supply needs ruling out before you condemn the module.
How it's tested: Clear the code and see if it returns. Load-test the battery and check the module's power and ground connections. Only replace or reprogram the module once supply voltage is confirmed good.
Common causes
- →A failed or interrupted ECM flash or tune update
- →A low-voltage event during programming
- →An internal ECM fault
What to check first
- Check battery voltage and connections
- Re-flash the ECM with a known-good calibration
- Replace the ECM if the fault persists
Is it safe to ride?
An ECM fault can cause unpredictable running. Have it diagnosed before riding.
Related ecm internal faults codes
How to read codes on your Harley
Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:
- Hold the odometer/trip button in and turn the ignition on.
- Release the button when the gauge lighting comes on. The display enters diagnostic mode.
- Tap the button to step through each module. Modules with nothing stored show "none".
- On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.
Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.
Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.