Mon–Fri 9am–5pm · (902) 755-6532

Chassis (C) · ABS

Harley Code C1184

ABS invalid VIN from ECM

Ride with caution

What C1184 means

The ABS module's stored VIN doesn't match the ECM, or it didn't receive one. This usually follows a module replacement.

Common causes

  • →A replaced ABS module or ECM
  • →Communication faults between modules

What to check first

  1. Have the modules programmed with the correct VIN

Is it safe to ride?

ABS may be disabled until the modules are paired.

How to read codes on your Harley

Most fuel-injected Harleys from 2004 on can show stored codes on the speedometer without a scan tool:

  1. Hold the odometer/trip button in and turn the ignition on.
  2. Release the button when the gauge lighting comes on. The display enters diagnostic mode.
  3. Tap the button to step through each module. Modules with nothing stored show "none".
  4. On 2014 and later Touring models, use the left hand-control toggle instead of the odometer button.

Newer bikes name each module (ECM, BCM, ABS, speedometer, radio). Older ones use letters, such as P for the engine module and B for ABS.

Current or historic? Clear the codes, ride the bike, then check again. A code that comes back is a current fault. One that doesn't was historic. Historic codes also clear themselves after about 40 trouble-free ignition cycles. The exact procedure varies by model and year, so check your owner's or service manual.

(902) 755-6532
Book Service